Swissbit’s 3D-NAND-SSD Suits Industrial Applications

July 22, 2019 Alix Paultre

Swissbit introduced a family of 3D-NAND-SSD products optimized for demanding industrial- and NetCom applications, with product versions with 2.5-inch housing, and m.2-, SlimSATA- and mSATA-modules. Using Toshiba BiCS3 NAND specified and pretested from -40 and 85°C, the industrial SATA-6-Gb/s-SSDs have Flash controllers that support a 165-bit-LDPC error correction.

The 2.5-inch SSDs from the X-75 family will be available from 60GB to 2TB in both commercial and industrial temperature grades, with a direct TLC write mode without SLC cache, which reduces Write Amplification Factor (WAF) and maintains a high sustained write data rate. The firmware achieves maximum endurance out of the 3000 P/E cycles specified for the 3D-NAND components.

The use of SLC-Cache for the 60 and 120 GB X-75-drives further improves top performance. Data Care Management with background scan, Near Miss ECC, and complete protection of internal data paths (E2E DPP - End-to-End Data Path Protection) offers additional safety against data loss. The firmware applies an efficient Block RAID for all drives, which allows recovery of full page fails.

For more information, visit www.swissbit.com.

Previous Article
STMicro’s Dual-Interface Secure MCU Serves Contactless Banking and e-ID Apps

STMicroelectronics’ ST31P450 dual-interface secure microcontroller is built on the 32-bit Arm SecurCore SC0...

Next Article
Diodes Inc’s Boost Controller for LED/LCD Apps Delivers 1~100 Percent Dimming Range

Diodes Incorporated introduced the AL3353 LED/LCD 40V max input boost controller.