OmniVision Releases Automotive SoC for Rear and Surround View Cameras

September 18, 2019 Laura Dolan

OmniVision’s 1.3MP OX01F10 SoC incorporates a 3.0-micron image sensor and image signal processor (ISP), overcoming roadblocks associated with automotive rear-view camera (RVC) and surround view system (SVS) using only one printed circuit board (PCB). 

The SoC uses OmniVision’s dual conversion gain (DCG) technology to obtain a high dynamic range of 120dB with only two captures, reducing motion artifacts while consuming 30 percent less power and enhancing low-light performance.

The OX01F10 SoC also:

  • Features lens chromatic aberration correction
  • Has advanced noise reduction and local tone mapping
  • Offers optimizations for the on-chip image sensor’s PureCel Plus technology
  • Provides 1.3MP resolution and a 1340x1020 array size at 30 fps
  • Enables output flexibility with 2-lane MIPI and 10-bit DVP interfaces
  • Is AEC-Q100 Grade 2 certified

OmniVision will be exhibiting the OX01F10 SoC at its AutoSens conference in Brussels from September 17-19, 2019 in booth #29.   

For more information, visit www.ovt.com.

To learn more about OmniVision, check out:

OmniVision Releases Automotive Image Sensor Fusion

OmniVision Releases Image Sensor with Tiny BSI Global Shutter Pixel

OmniVision Expands Nyxel NIR and ULL Sensor Resolution to 4 MP

Previous Article
ByteSnap to reveal the destination for EV charge points at EDS 2019

Award-winning embedded systems consultancy ByteSnap Design will showcase “Smart Charging” solutions for ele...

Next Article
Ericsson performs novel 5G coverage and performance verification using drone-powered solution from Rohde & Schwarz

Test and measurement specialist Rohde & Schwarz has supplied mobile network testing tools used in dronebase...