OmniVision Releases Automotive SoC for Rear and Surround View Cameras

September 18, 2019 Laura Dolan

OmniVision’s 1.3MP OX01F10 SoC incorporates a 3.0-micron image sensor and image signal processor (ISP), overcoming roadblocks associated with automotive rear-view camera (RVC) and surround view system (SVS) using only one printed circuit board (PCB). 

The SoC uses OmniVision’s dual conversion gain (DCG) technology to obtain a high dynamic range of 120dB with only two captures, reducing motion artifacts while consuming 30 percent less power and enhancing low-light performance.

The OX01F10 SoC also:

  • Features lens chromatic aberration correction
  • Has advanced noise reduction and local tone mapping
  • Offers optimizations for the on-chip image sensor’s PureCel Plus technology
  • Provides 1.3MP resolution and a 1340x1020 array size at 30 fps
  • Enables output flexibility with 2-lane MIPI and 10-bit DVP interfaces
  • Is AEC-Q100 Grade 2 certified

OmniVision will be exhibiting the OX01F10 SoC at its AutoSens conference in Brussels from September 17-19, 2019 in booth #29.   

For more information, visit www.ovt.com.

To learn more about OmniVision, check out:

OmniVision Releases Automotive Image Sensor Fusion

OmniVision Releases Image Sensor with Tiny BSI Global Shutter Pixel

OmniVision Expands Nyxel NIR and ULL Sensor Resolution to 4 MP

Previous Article
ByteSnap to reveal the destination for EV charge points at EDS 2019

Award-winning embedded systems consultancy ByteSnap Design will showcase “Smart Charging” solutions for ele...

Next Article
C2A Security and NXP Join Forces on Cybersecurity for Connected and Automated Vehicles

C2A’s combined solution with NXP addresses demand for “iron-clad” perimeter cybersecurity protection for ve...