Digital oscilloscopes integrate true spectrum analyzer, waveform generator, PSU

September 7, 2017 ECD Staff

Saelig’s GW Instek MDO-2000E Series Oscilloscopes include two instrument combinations that integrate multiple test instruments in a single enclosure, including a true built-in spectrum analyzer and arbitrary waveform generator.

The two- or four-channel MDO-2000EX features a 5,000-count DMM and 5V/1A power supply, and is available in 70 MHz, 100 MHz, and 200MHz bandwidths.

MDO-2000EG models feature a dual-channel 25 MHz arbitrary waveform generator in addition to the true spectrum analyzer.

Compared to conventional digital oscilloscopes that rely on FFT calculations over the entire signal bandwidth, MDO-2000E series units analyze a defined signal spectrum of interest for higher resolution results. Users can input data of interest regarding the signal such as center frequency, start/stop frequency, and span to conduct measurements in both the time and frequency domains.

The MDO-2000E digital oscilloscopes are capable of testing signals below 9 kHz, as well as signals with a DC component. They offer the same capabilities as real-time spectrum analyzers, but faster than frequency sweeping.

MDO-2000E oscilloscopes are available now. Visit http://www.saelig.com/category/gds-2000e.htm for more information.

 

Previous Article
Docking connector for motor-control center adds test position
Docking connector for motor-control center adds test position

Previously, docking connectors only featured “plugged in” and “not plugged in” states. Now, three different...

Next Article
Open-Q 626 system-on-module
Open-Q 626 system-on-module

Intrinsyc’s Open-Q 626 system-on-module (SOM) is an ultra-compact (50- by 25- mm) production-ready SOM that...