|Pentek JadeFX FMC Carrier for 3U VPX|
Pentek introduced the JadeFX Model 5983, a 3U VPX carrier board for FMC and FMC+ modules based on the high performance Xilinx Kintex UltraScale FPGA. The Model 5983 includes a VITA-57.4 FMC site providing access to a wide range of I/O options. When combined with any of Pentek’s Flexor FMCs to create a FlexorSet, it becomes a complete multichannel data conversion and processing subsystem suitable for connection to IF, HF or RF ports of a communications or radar system.
The Model 5983 is the carrier foundation for a new series of FlexorSets capable of hosting FMC and FMC+ modules. The check-off for enhancements include:
1.5X higher performance utilizing 15% less power with the Kintex Ultrascale FPGA
2.8X increase in FMC bandwidth potential with the new FMC+ standard
1.5X faster memory transfer rate with 9 GB of DDR4 SDRAM
Optional GPS for precise data tagging for time and position
Optional 12 GB/sec VITA-66.4 optical backplane I/O
Navigator BSP and FDK for streamlined IP development
The Pentek JadeFX Architecture defines Pentek FMC and FMC+ carrier boards based on the Xilinx Kintex UltraScale FPGA, which raises the digital signal processing (DSP) performance by 1.5X with equally impressive reductions in cost, power dissipation and weight. As the central feature of the JadeFX Architecture, the FPGA has access to all data and control paths, enabling factory-installed functions including data multiplexing, channel selection, data packing, gating, triggering and memory control. A 9 GB bank of DDR4 SDRAM operating at 2400 MHz is available to the FPGA for custom applications. The x8 PCIe Gen 3 link can sustain 6.4 GB/s data transfers to system memory. Eight additional gigabit serial lanes and LVDS general-purpose I/O lines are available for custom solutions.
The Model 5983 supports the ANSI/VITA-66.4 optical interconnect standard that provides up to 12 optical duplex lanes to the backplane. With the installation of a serial protocol, the optical interface enables gigabit backplane communications between boards at up to 12 GB/sec independent of the PCIe interface.
The Model 5983 JadeFX carrier is designed to operate with all of Pentek’s Flexor FMC and FMC+ modules. When integrated as a FlexorSet package, the Model 5983 is delivered with factory-installed intellectual property (IP) modules ideally matched to the FMC’s analog or digital interfaces. These include A/D acquisition and D/A waveform playback engines for simplifying data capture and playback.
Navigator Design Suite for Streamlined IP Development
Pentek's Navigator® Design Suite consists of two components: Navigator FDK (FPGA Design Kit) for integrating custom IP into Pentek sourced designs and Navigator BSP (Board Support Package) for creating host software applications. The FDK includes factory-installed modules as documented source code. Developers can integrate their own IP with the Pentek factory-installed functions or use the Navigator kit to completely replace the Pentek IP with their own.
Users can work efficiently at the API level for software development and with an intuitive graphical interface for IP design. The Navigator BSP is available for Windows and Linux operating systems.
Pre-Configured SPARK System Ready for Immediate Use
With a Pentek 8267 SPARK® 3U VPX development system, work can begin immediately on applications. A SPARK system saves engineers time and expense associated with building and testing a development system and ensures optimum performance of Pentek boards. SPARK development systems are ready for immediate operation with software and hardware installed. In many applications, the SPARK development system can become the final deployed application platform.eletter-01-26-2018