IQRF - wireless technology for IoT and how to use it

August 24, 2018 Jan Pešl, IQRF Alliance

IQRF technology is used for wireless data transfer. The transmission is capable of overcoming large distances (up to 500 m outdoors, tens of meters indoors). Usually small data packages, device statuses or control signals are transferred from and to sensors. The transmission works in the unlicensed (ISM) frequency band 868 MHz, 433 MHz or 916 MHz.

The IQRF network contains a single control unit, which usually operates synchronously with other devices in the network. The coordinator instructs the nodes to collect data or sends control commands to the nodes. The network has one coordinator and up to 239 nodes. All devices in the same IQRF network operate on the same channel. Devices in the IQRF network can work in a mesh topology (each device can receive the signal from multiple neighbors). Every node transmits data in its own time interval, to avoid collisions and to ensure high reliability of delivery. 

Connecting the device to coordinator in the IQRF network (Bonding)

To create a network, pairing (bonding) of a coordinator and nodes must be done. This can be done in various ways.

One option is to do it manually when coordinator and nodes are in direct range. The bonding procedure on the coordinator side is usually initiated by a control software. Logical address of the new node is selected, and coordinator is listening for 10s to receive a bonding packet from a new node. On the node, side bonding is usually initiated by pressing a particular button. Once the bonding procedure is finished, the nodes receive the logical address. When this is done on all nodes, the network is basically built and nodes are ready to receive commands from the coordinator.

Exploring the network (Discovery)

The next phase of creating functional network is discovery. Place the nodes on their positions (each of the nodes should optimally be within radio range of at least three neighboring nodes) and then run the discovery command on the coordinator. During this procedure, the coordinator explores topology of the network. VRNs (Virtual Routing Number) are assigned to the nodes during this process. VRN expresses its physical location in the network. Once the discovery is completed, the network is ready for the optimal data distribution.

Disconnecting the node from the coordinator

In the instance the device is paired with a coordinator that is no longer available, the disconnection process usually has to be performed on the node before connecting the new coordinator. This process can be done in various ways, typically by pressing a particular button.

Connecting to a computer network

Devices in an IQRF network communicate with a computer network (computers in LAN network or internet) through a gateway. The gateway translates the communication between the IQRF network and the computer network. There are several types of gateways – Ethernet, GSM, USB or Wi-Fi gateway.

The gateway usually plays the role of a coordinator in the IQRF network.

The address of cloud storage (e.g. IQRF Cloud) is usually configured in the gateway firmware by default. Data can be stored and accessed via the applications to read them, evaluate them and to send the commands back to devices in the IQRF network.

For more information, contact jan.pesl@iqrf.org

eletter-08-28-2018

eletter-08-27-2018

Previous Article
Mentor’s Emulation Vision – New Solutions for New Challenges

What has changed – and what will change more dramatically going forward – are the specific use cases and bo...

Next Article
u blox’s UBX-P3 will accelerate V2X active traffic safety
u blox’s UBX-P3 will accelerate V2X active traffic safety

u-blox announced its UBX P3 chip for vehicle-to-everything (V2X) wireless communication based on the DSRC/8...

×

Follow our coverage of networking-related design topics with the Networking edition of our Embedded Daily newsletter.

Subscribed! Look for 1st copy soon.
Error - something went wrong!